2300型数字刺激隔离器A-M SYSYTEM

The Model 2300 Digital Stimulus Isolator provides opto-electrical isolation and amplitude control for square pulses whose timing parameters are generated by your computer. These levels are set by the front-panel ten-turn potentiometers. Scaled according to the Range switch setting, these levels can result in an output up to 50 V or 5 mA.

2300 型数字激励隔离器为方波脉冲提供光电隔离和幅度控制，其定时参数由计算机生成。这些电平由前面板的 10 圈电位计设置。根据量程开关设置进行缩放，这些电平可产生高达 50 V 或 5 mA 的输出。

The Model 2300 can generate monophasic or biphasic pulses when provided with three TTL control signals: On/Off, Baseline/Pulse, and Polarity.

2300 型在提供三个 TTL 控制信号时可以产生单相或双相脉冲：开/关、基线/脉冲和极性。

“On/Off” determines if the Model 2300 output section is enabled.

“On/Off” 确定是否启用了 Model 2300 输出部分。

Baseline/Pulse determines if the front panel Baseline potentiometer or if the front panel Pulse setting determines the output level.

Baseline/Pulse 确定是前面板的 Baseline 电位计还是前面板的 Pulse 设置决定输出电平。

Polarity determines if the output is positive or negative.

极性确定输出是正还是负。

By strategically controlling the values of these three TTL control signals, you can control the pulse timing and the output parameters.

通过战略性地控制这三个 TTL 控制信号的值，您可以控制脉冲定时和输出参数。

If for any reason the instrument cannot follow the input signal, an Error indicator lights. The isolated output section is battery-powered and optically-coupled to the input section, for complete signal isolation.

如果由于任何原因仪器无法跟踪输入信号，则错误指示灯会亮起。隔离输出部分由电池供电，并与输入部分进行光耦合，以实现完全的信号隔离。

The battery is adequate to provide full function for at least 8 hours of continuous use. An internal battery tester is provided. A charger is supplied, and an overnight charge cycle is all that is required to ready the 2300 for another day’s use.

电池足以为至少 8 小时的连续使用提供完整的功能。提供内部电池测试仪。提供充电器，只需一个过夜充电周期即可为 2300 准备好改天使用。